TEMS 9 & Actix

[justdream]

Guys,

could our Actix open TEMS 9 logfiles?

also,

how could you perform UMTS scanning test using TEMS 9 and Z750i? Please, give me the steps once I open TEMS 9 and connect Z750i

Thanks

[raedsab]

Yes Actix 4.05.168.194 can open Tems 9.0 logfiles directly!

[raedsab]

<TABLE cellSpacing=0 cellPadding=0 summary="" border=0><TBODY><TR style="VERTICAL-ALIGN: baseline"><TD width="100%">TEMS Investigation Data Collection supports scanning of UMTS frequencies with one of the following devices:
• Sony E******* Z750i phone operating in scan mode
• PCTel SeeGull LX/EX scanner
• Anritsu ML8720/8740/8741 scanner.
Scanning tasks are set up from the Equipment Control toolbar.
On the Equipment Control toolbar, choose the scanning device in the left combo box, and choose “[WCDMA] Spectrum Analysis” in the right combo box.

</TD></TR></TBODY></TABLE>
On the Equipment Control toolbar, click the Scan Properties button.
Two charts are provided, one for the downlink (Spectrum Analysis Bar Chart) and one for the uplink (Spectrum Analysis Uplink Bar Chart).They both display RSSI as a function of frequency.

[justdream]

Guys, could I use external antenna with sony e******* Z750I or not,

if I didn't use and want to compensate the difference, how much dB's should I subtract from my reading to compensate?

Hint: I have Actix 4.04, did it work with you correctly with TI 9 logfiles?

[justdream]

Guys,

I used TEMS9 with Z750i for UMTS scanning "exactly WCDMA CPICH scanning" as shown in the left pic


consequently, I exported SC best Aggr Ec (dBm) to get the measured signal strength......ok

now in Actix 4.05 how could I get and export the same information?

I attached A snapshot from Actix (the right picture) after I opened the logfile in it

[justdream]

could any friend answer my adove question? Thanks

[gsmman2006]

Dear All,
I need to scanning 900 , 1800 , 2100 MHZ band ferquecny.
I have Tems 9.1 and Z750i , also I dont have any simcard for WCDMA , is possible I test ferquency band 2100 ???

please guide me '


thank you

[kamy]

Dear All,
I need to scanning 900 , 1800 , 2100 MHZ band ferquecny.
I have Tems 9.1 and Z750i , also I dont have any simcard for WCDMA , is possible I test ferquency band 2100 ???

please guide me '


thank you

you can select emegency call for testing only

[kamy]

Guys,

I used TEMS9 with Z750i for UMTS scanning "exactly WCDMA CPICH scanning" as shown in the left pic


consequently, I exported SC best Aggr Ec (dBm) to get the measured signal strength......ok

now in Actix 4.05 how could I get and export the same information?

I attached A snapshot from Actix (the right picture) after I opened the logfile in it

the query function in actix will help you, but it requires you some time and experience