PDA

View Full Version : Shift BCCH to specific TRX



electron
2010-08-29, 05:52 PM
Hi friends,


an you please advice how we can locate(shift) BCCH frequency on specific TRX in E******* BSCs?


Thanks,

s52d
2010-08-29, 06:29 PM
Hi friends,


an you please advice how we can locate(shift) BCCH frequency on specific TRX in E******* BSCs?


Thanks,

Hi!

Halt current BCCH TRX and BCCH will move to another TRX.
Repeat until you are satisfied.

Beware: if some TRXes are not EDGE capable, you might get cell with no EDGE.
(In fact, this is common problem after some antenna/TRU failure)

BR
s52d

electron
2010-08-29, 07:37 PM
Thanks,


This way that you mentioned is a system capability when TRX (TRU) which BCCH is located on that get faulty automatically BCCH will shift because of cell being working normally .Any how i'm sure there is a way which will allow us to shift BCCH to specific TRX on a cell.

electron
2010-08-30, 03:13 PM
Any advice friends...

zee86
2010-09-05, 06:56 AM
Thanks,


This way that you mentioned is a system capability when TRX (TRU) which BCCH is located on that get faulty automatically BCCH will shift because of cell being working normally .Any how i'm sure there is a way which will allow us to shift BCCH to specific TRX on a cell.

its depend on the configuration how u want there are different configuration in which u tei your BCCH with specific TRX

electron
2010-09-05, 09:53 PM
Thanks for replay,


Could you please explain more and give me the procedure practically ?


Thanks

radenmohawk
2010-09-06, 02:56 AM
you can use command BLOCK and DEBLOCK TRX on winfiol..

RXBLI:MO=RXOTRX-309-0,Subord,force; --> command for BLOCK TRX (TG:309 , TRX:0)
RXBLE:MO=RXOTRX-309-0,Subord; --> command for DEBLOCK TRX (TG:309 , TRX:0)
RXCDP:MO=RXOTG-309; --> for check TRX/TS configuration (TG:309)

example the Site have 4/4/4 configuration, usually BCCH on TRX 0(Sec1), 4(Sec2) and 8(Sec3). you should check with command "RXCDP". Try BLOCK TRX-0 then please wait (some TS will be "unused" mode for a while) BCCH TRX/TS on Sector1 will move to TRX-1/2/3, check again with command "RXCDP" whether BCCH TRX/TS already move. Don't forget to unblock TRX-0 to avoid TCH congestion.

auto_art
2011-01-07, 01:55 AM
the most effectvie way to keep bcch ona specific TRX...

during TEI defination do not define chgr0 on TEI's where u dont want to shift BCCH..this way BCCH will not be able to get shift automatic and stik to particular TRX only...

hope u got it..!!